Prevent hyper-flashing. When you replace incandescent turn signal bulbs with LEDs in most vehicles, the vehicle will start hyper-flashing. This is because the LED uses much less power, and the vehicle thinks the bulb is out. You can easily fix this problem by installing resistors.
To install, connect one side of the resistor to the positive turn signal wire, and the other side to negative (ground) with included connectors. To determine which wires to tap on a dual filament socket, we recommend using a voltmeter to test the two power wires. Simply engage your turn signal on the side you're installing the resistor, touch your voltmeter probe to each pin inside of the socket, and the pin that gives a voltage readout is the power wire that needs to be tapped. Typically the ground wire is a black wire.
Two (2) resistors
Four (4) quick-splice connectors
Optional unique VO mounting brackets make the installation much easier with a single bolt securing method
Have a question? Help is on the way. Simply fill out the form below and we will email you back. Please include details about your vehicle (make/model/year) and which products you are interested in. Can't wait? Call us directly at (424) 250-0270.